How to Install Arris CM3200 Cable Modem

To install the Arris CM3200 Cable Modem, follow these steps:

  1. Unpack the modem and connect the coaxial cable from your cable service provider to the “Cable In” port on the modem.
  2. Connect an Ethernet cable from the modem to your computer or router.
  3. Power on the modem by plugging it into an electrical outlet.
  4. Wait for the modem to fully boot up and establish a connection to your cable service provider.
  5. Open a web browser and enter “192.168.100.1” in the address bar to access the modem’s web-based setup page.
  6. Log in to the modem using the default username and password, which can be found in the modem’s user manual.
  7. Navigate to the “Status” or “System Info” section of the modem’s web interface to verify that the modem has established a connection to your cable service provider.

Note: If you encounter any issues during the setup process, please refer to the product manual for additional information and instructions.

 

How to Factory Reset Arris CM3200 Cable Modem

To factory reset the Arris CM3200 Cable Modem, follow these steps:

  1. Locate the reset button on the back of the modem. It is usually a small hole labeled “Reset” or a recessed button.
  2. Using a paperclip or similar object, press and hold the reset button for 10-15 seconds until the modem’s lights start flashing.
  3. Release the reset button and wait for the modem to fully reset and restart.
  4. Once the modem has restarted, verify that the modem’s lights are stable and that it has established a connection to your cable service provider.
  5. If necessary, log in to the modem’s web-based setup page using the default username and password (found in the modem’s user manual) and reconfigure your network settings as desired.

Note: Factory resetting the modem will erase all of your custom settings and return the modem to its original configuration. Before resetting the modem, be sure to make note of any important settings that you may need to reconfigure later.

 

How to Add a Wireless Router to Arris CM3200 Cable Modem

To add a wireless router to the Arris CM3200 Cable Modem, follow these steps:

  1. Connect the Arris CM3200 Cable Modem to your cable service provider’s coaxial cable using the coaxial cable connector.
  2. Connect the WAN port of the wireless router to one of the LAN ports of the Arris CM3200 using an Ethernet cable.
  3. Connect the power cord of the wireless router to an electrical outlet and turn on the router.
  4. On a computer or device connected to the wireless network, open a web browser and enter the IP address of the wireless router’s web-based setup page (found in the router’s user manual).
  5. Log in to the router’s setup page using the default username and password (found in the router’s user manual).
  6. Follow the instructions on the router’s setup page to configure the wireless network settings, such as the SSID and password, and to disable the router’s DHCP server.
  7. Save the changes and restart the router.
  8. Verify that the wireless network is up and running by connecting a device to the network and testing the internet connection.

Note: When adding a wireless router to the Arris CM3200 Cable Modem, it is recommended to set the router to bridge mode to avoid any IP address conflicts or other network issues. This can typically be done in the router’s setup page.

Did we answer all your questions about the Arris CM3200 Cable Modem? Let us know in the comments, or leave your own questions for our technicians to answer!

Leave a Reply

Your email address will not be published. Required fields are marked *