Starlink Wall Mount for Standard Kit Dish

The Starlink Wall Mount fixes a Starlink Standard dish to an exterior wall near the roofline, where it has the widest view of the sky. It replaces the kickstand for a permanent install and reaches out far enough to clear a roof overhang of up to 4 inches. It fits the Standard 4, Standard 4 X, and Enterprise dishes.

Quick Specs

Where It Mounts

Starlink designs this mount for the top of a gable wall or the fascia board, the two places on most houses that sit above nearby obstructions. Run the Starlink app's obstruction check from that spot before you drill. The app uses your phone camera to confirm the dish will have a clear view of the sky from the mounted position.

Tools You Need

• Drill with a 1/4 in (6 mm) bit
• Socket wrench with a 9/16 in (14.2 mm) socket
• Stud finder that also detects wiring
• Level and pencil

Drive the lag screws into solid framing, not siding or sheathing alone. Seal the holes with the included silicone, and use the wall clips to hold the cable along the wall on its way indoors.

Compatibility

This mount fits the current flat Standard dish that ships in the Starlink Standard Kit, along with the Enterprise dish. The older Gen 2 (Standard Actuated) dish with a motorized mast and the Starlink Mini use different mounts. To put a Standard dish on a pole or an old antenna mast, use the Starlink Pipe Adapter.

Frequently Asked Questions

Which Starlink dishes fit the Wall Mount?

The Starlink Standard 4, Standard 4 X, and Enterprise dishes. It does not fit the Gen 2 Standard Actuated dish or the Starlink Mini.

How much roof overhang can the Starlink Wall Mount clear?

Up to 4 inches (10 cm).

What comes with the Starlink Wall Mount?

The mount, 2 lag screws, silicone sealant, and 40 wall clips. The dish and cable come from your Starlink kit.

Do I need a professional to install it?

No, but the job involves a ladder and drilling into the house near the roofline. Hire an installer if you are not comfortable working at that height.